This is how I make the template to use with the Torque Workcentre….
in overhead pin routing mode.
This particular template will be for limited production runs of a new line …
Camphor Laurel cheese paddles.
You can use this process to make a template of just about anything…
I will be making a template for Racing Kangaroos next..
Stay tuned..
Please note the guard on the router was removed during this demonstration
to enable a clearer shot of the procedure..
Please do not do this at home…
Looks like you have that process down solid. I am a fan of templates for many reasons. Unfortunately, one of the reasons doesn’t work out so well sometimes for me. Flush trimming is more of a challenge than I thought. Are you using a flush trim up-or-down spiral bit?
you make it look easy
Pingback: The Next Step « Lazy Larry's Workshop
Pingback: A Do-hickey « Lazy Larry's Workshop
I would like to look at the video, but it will not allow.