Double Step Board..


Unfortunately, I did not take any pictures of the actual glue up..

Which by the way was a real bugger…

I used the standard two fixed and two loose cauls but had a lot of slippage …

I did manage to remember to take these of the board just out of clamps and on the TWC for flattening … using the 55 mm surfacing cutter bit in the router…..
These are after the board had been squared on the table saw… using the Incra Mitre express to square the ends…

Looking not too shabby…even with all the mistakes…

You don’t have to look too hard to see where the slippage is ….I think it adds character… lol

A little bit more burnishing with finer sand paper and several coats of mineral oil and it will be ready to post as a finished project…

About Lazy Larry

Just a woodworker sharing some of the things learnt the hard way... so you don't make the same mistakes...
This entry was posted in General, project, workshop and tagged , , , , , . Bookmark the permalink.

One Response to Double Step Board..

  1. Michael Wurm says:

    WONDERFUL LOOKING 3D BOARD. DON’T HAVE A CLUE HOW YOU MANAGE TO KEEP ALL THE PIECES RIGHT FOR GLUE UP. YOU ARE THE WIZARD OF ODD, AND RARE. GORGEOUS.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s