Galley door update.


Taken longer than expected..due to the additional steps to each of these doors…and the fact that I keep putting it off… sidetracked with other projects..

As you can see all the mortices and tenons have been cut…[using the Leight FMT]

I have also cut the Chamfers on the inside edges of the door frames… this was done with a piloted chamfering router bit while the frames were clamped together…

You will also notice that I have taken the time and effort to match the grains both in the styles… and across the rails… these are pairs of small doors…12 all together…

The other doors are all one per opening but I still tried to cut the parts from one piece of timber…

A slot cutting bit was set in the old router table and the groove for the floating panel cut…

These are all done now… just need to cut rebates fore and aft on the panels.. 4 mm at the back and 7 mm in the front and then using a V-groove bit …make a chamfer on the raised panel… When assembled the door will have a Vee profile….

So that is where I am up to….. in the workshop doing a bit more routing…

stay tuned…

About Lazy Larry

Just a woodworker sharing some of the things learnt the hard way... so you don't make the same mistakes...
This entry was posted in General, project, techniques, workshop and tagged , . Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s