Business card holders…


I mentioned these in a previous post… here is how I made them…

Start by making a blank of striped timbers…Adjust the SCMS to 5 – 10 degrees.. and cut the first end..Using marks on the fence cut the three parts …. front, middle and back…

You can see how this is coming together…Glue up the pieces using spring clamps to hold while the glue dries…

Sand and complete with your choice of finish…. I used a quick spray can of satin poly… great from small items like this… then added some felt underneath to protect the table…

About Lazy Larry

Just a woodworker sharing some of the things learnt the hard way... so you don't make the same mistakes...
This entry was posted in General, project, techniques and tagged , , , , , . Bookmark the permalink.

2 Responses to Business card holders…

  1. Lew says:

    Cool how-to, Larry! Thanks!!

  2. Eric R says:

    Thanks for the show & tell mate.
    Your selection of different timber is always top rate.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s